Posted in System components - for temperatures up to 145°C

Insulated pipeline ends

Installed at the end of pipeline and insulated. Can be part of component (T-branch) or we can just deliver material for insulation on construction site.


The end cup

Watertight cap, which closes the insulation at the end of the pipeline .Made of shrinking material, can be assembled at the construction, or delivered already installed on the component.



Compensating foam pads

Posted in System components - for temperatures up to 145°C

Compensating foam pads

Compensating pads allow dilatation movements of an element at the end of straight section. They are made  of polyethylene with increased thermal stability and can be easily welded by hot air gun .

Other typical characteristics of pads are:

  •          high elasticity in temperatures-70°C to+85°C
  •          good shock absorption effect
  •          high terminal insulation ability
  •          low water absorption
  •          high resistance factor against water vapour diffusion
  •          good chemical resistance

Suspension characteristic  and compressive stress

  •          Material compressive stress at 25% deformity – 48 kPa
  •          Material compressive stress at  50% deformity– 116 kPa
  •          Material compressive stress at 75% deformity– 325 kPa

Thermal conductivity

Because this substance has small cells and small specific weight, it has as very good thermo-insulating ability - lambda = 0,040 W / mK.

The table of used dimensions ( pad width is standard h = 40 mm):


Wall bush

Posted in System components - for temperatures up to 145°C


Wall bushes are used for sealing against the penetration of water in places where pipes go through walls, sockets, well walls etc.

transition through the wall in demanding conditions

Prevents moisture penetration along the pipe into the building. It is plastic sliding pipe with a collar, inner diameter of which corresponds to the outer diameter of casing pipe. The space between the sliding pipe and  casing pipe is sealed with shrink foil – supplied by Pipeco Slovakia.



Posted in System components - for temperatures up to 145°C

Standard dimensions:


Length is valid for 1 size reduction. When there is more than 1 size reduction, L can be higher 50 - 100 mm.

Production range for basic insullation:

Nonstandard execution:

Placing on other elements (T-branch, P-branch).


Posted in System components - for temperatures up to 145°C

Permanently working :
L = 2500 mm (DN < 300)
L = 3000 mm (DN > 350

For PN 1,6 MPa, PN 2,5 MPa, PN 4,0 MPa

Delivered is pre-stressed to full length.


Starting (axial bellows type ):

L = max 820 mm (DN < 300)
L = min 840 mm (DN > 350)


Delivered as non-insulated. After thermal expansion and pipe pre-stress, compensator  must be welded and insulated by supplied components.

For PN 1,6 MPa, PN 2,5 MPa



More Articles ...